Line Keys and Softkeys
41-001452-00 Rev 00 – 07.2011 110
None Key
You can set a softkey, or expansion module key to force a blank entry on the IP phone display for a specific key. You do this
by setting the key to "none". The keys are added in order (from key1 to key20) after any hard-coded keys have been added.
If a particular key is not defined, it is ignored. For more information about key behavior, see “Key Display Behavior” on
page 56.
Configuring a None Key
Use the following procedure to configure a None key on the 6737i IP Phone. The procedure shows the softkey screen as an
example.
Aastra Web UI
1. Click on Operation->Softkeys and XML.
or
Click on Operation->Expansion Module <N>.
Softkeys
2. Select from “Key 1” through “Key 10” on the Top keys.
or
Select from "Key 1" through "Key 20" on the Bottom keys.
3. In the "Type" field, select None.
Expansion Module Keys
4. Select from “Key 1” through “Key 36” (M670i)
or
Select from “Key 1” through “Key 60” (M675i)
5. In the "Type" field, select None.
6. Click Save Settings.
VoIPon www.voipon.co.uk sales@voipon.co.uk Tel: +44 (0)1245 808195 Fax: +44 (0)1245 808299
www.InternetVoipPhone.co.uk | sales@internetvoipphone.co.uk | 0800 088 4846
To Next Page
Loading...
