Page 150 01/2007 AMT/PTD/PBX/0020/2/4/EN
• The compensation of the synchronization signal propagation time between the "Slave" PBX
and the "Master" PBX must be defined: 5 switches are used (serial printing: RET4-0, each
switch = step of 100 meters).
Note:
Binary value : ON = 0 ; OFF = 1
When adding a synchronization delay, the ON position of the switches signifies 0
(and thus a delay of 0 seconds).
• Check the configuration of switches CA1, CA3 and CA4 on the CSI card. Their configuration
must be the same as the factory configuration (see mono-site synchronization).
• Check the configuration of switches CA1, CA2 and CA3 on the RMH cards (see mono-site
synchronization).
Distance
(in meters)
RET 4 RET3 RET2 RET1 RET0
0 à 100 on on on on on
100 à 200 on on on on OFF
200 à 300 on on on OFF on
300 à 400 on on on OFF OFF
400 à 500 on on OFF on on
500 à 600 on on OFF on OFF
600 à 700 on on OFF OFF on
∆T 900 5 5,× 4950ns==
V
9760 4950–
488
------------------------------
9 856,==
To Next Page
Loading...
