Page 34 01/2007 AMT/PTD/PBX/0020/2/4/EN
2.3.2 Configuring an M90x mobile terminal
Registering an M90x mobile terminal
A. Check that the mobile has not already been registered.
The cordless handset must not contain any "parasite" registrations (for example, from previous
use on another DECT system). In the standard case where the mobile is to be used on one
DECT system only, it must not be registered on any other base at the outset.
• At startup, if the mobile displays:
it is not currently registered on any other base. Press the OK key
and proceed to step 7 under paragraph B).
• If the mobile displays:
it is already registered on at least one other base.
1
Press the Menu key
2
Press the middle key until "Select base" is displayed
3
Press the Select base : key
• Any base numbers already in use are displayed. These numbers must be de-registered
on the mobile.
B. Register the mobile on a base
1
Press the Menu key
2
Press the middle key until “Personalize” is displayed
3
Press the Personalize key
4
Press the middle key or several times until "Declare" is displayed
5
Press the Declare key
The display shows: "Declare base no? 1 2 3 4 5 6 7 8".
6
Press the or key to select base 1 2 3 4 5 6 7 8.
Normally, 1 blinks and you just have to press the OK key.
Declare mobile set
to rbs nbr ?
1 2 3 4 OK
½
½
Mobile set
out of range
bis
Menu ½
½
¾
½
½
¾
¾
½
¾
¾
½
¾
To Next Page
Loading...
