AMT/PTD/PBX/0020/2/4/EN 01/2007 Page 163
Chapter 9 - Programming for the NeXspan
C/S/L/D range
9.1 Introduction
The steps for programming the DECT service are described for NeXspan C/S/L/D PBXs.
Note:
It is essential to follow the programming order given.
1 PRELIMINARY OPERATIONS:
• Check the "internal" type data routing (menu 2.5 "Data management/Routes")
2 MANAGING TOPOLOGY
Declare the cells
Declare the DECT parameters
3 MANAGING RESOURCES
Name the trunk groups.
Define a trunk group.
4 PUTTING THE DECT SYSTEM IN SERVICE
Delete S0 subscribers.
Put the DECT interface cards in service.
Put the DECT base stations in service (downloading).
5 CHECKING THE PROGRAMMING PARAMETERS
Display the base stations.
Display the coverage.
6 REGISTERING AND PUTTING IN SERVICE THE MOBILES
7 MANAGING REGISTRATION PASSWORDS
To Next Page
Loading...
