Aastra NeXspan 500 - 11.2 Declaring the radio zones on NeXspan 50; NeXspan 500

Page 188 01/2007 AMT/PTD/PBX/0020/2/4/EN
11.1.2 Non-contiguous multi-site configuration
It is not necessary to give the different cells different numbers in the MMCs.
The following MMCs must be implemented:
• Declare the same PARI on all the sites.
• Same RANDOM registration number on all the sites.
• Same RS registration number on all the sites.
• Same MOBILE registration password on all the sites.
Broadcast of call setup requests must be configured to reach the sites with base stations
• on NeXspan 50: MMC XSERVI
• sub-object "Radio zones", field "Zone= . ."
• sub-object "General", field "Addr-nat."= F4, 2nd byte=BF (All sites of all centers)
• on NeXspan C/S/L: menu 1.8.1.2 or 1.9.1.2 "DECT Parameters"
• parameter "search mobiles not registered"
Create a broadcast list A with all the sites where the DECT is present.
11.2 Declaring the radio zones on NeXspan 50 / NeXspan 500
MMC XSERVI
SERVICES MANAGEMENT
Obj.=Dept. Action=Display
Sub-Object=GENERAL
----------------------------- SERVICE ACCESS --------------------------
Template CCU=2.
KEY: Address-nature = F4 2nd byte (comp_ovflw) = FE
----------------------------- SERVICE DATA --------------------------
CCU selection mode = FIXED
Number of CCUs = 1
Sites and Clusters in Hex from 0 to FEH
1 : Site=BF CCU = ..
2 : Site=.. Cluster = ..
3 : Site=.. Cluster = ..
4 : Site=.. Cluster = ..
5 : Site=.. Cluster = ..
6 : Site=.. Cluster = ..
7 : Site=.. Cluster = ..
8 : Site=.. Cluster = ..
Subscr. number = ........
---------------------------------------------------------------------------
Report=O.K.
Operation performed