3 Installation
24 | 266 MODBUS® multivariable transmitter User manual 2105216 Rev. AB
HMI display rotation
The LCD can be oriented in four different positions, rotated clockwise or counterclockwise with 90° steps.
To rotate the LCD:
1. Remove the front housing cover.
IMPORTANT NOTE: Take precautions for any hazardous conditions.
2. Disengage the four (4) fixing locks by pressing in on each one with a small slotted screwdriver (Figure 19).
Figure 19: Display rotation
3. Pull the display housing out from the communication board.
4. Reposition the LCD connector to the new desired position.
5. Push the LCD module back onto the communication board.
IMPORTANT NOTE: Ensure that the four plastic fixing locks are properly in place by pressing in until the
display clicks.
6. Re-install the front housing cover.
To Next Page
Loading...
