ABB 266 MODBUS - Page 89

Appendix A HMI menu structure
266 MODBUS® multivariable transmitter User manual 2105216 Rev. AB | 81
Table 18: HMI menu structure, continued
Menu
Submenu 1
Submenu 2
Selections or Description
Device Setup
Set Diff. Press
Units
Pa
inH2068F
kg/cm2
Mpa
inH2060F
mmH2068F
bar
inH204C
ftH2068F
PSI
Torr
inHgOC
kPa
Atm
mmHgOC
mbar
g/cm2
Lower Range Value
Upper Range Value
Damping
Set Diff. Press Bias
Set DP To Zero
Applies a bias to make the current displayed
value equal zero
Set DP To value
Applies a bias to make current displayed
value equal the entered value
Reset DP Bias
This removes the user saved bias
Set Static Press.
Units
Pa
inH2068F
kg/cm2
Mpa
inH2060F
mmH2068F
bar
inH204C
ftH2068F
PSI
Torr
inHgOC
kPa
Atm
mmHgOC
mbar
g/cm2
Lower Range Value
Upper Range Value
Damping
Set Static Press. Bias
Set SP To Value
Applies a bias to make current displayed
value equal the entered value
Reset SP Bias
This removes the user saved bias
Set Proc. temp
Unit
Degree: °C, °F, °R, °K
Lower Range Value
Upper Range Value
Damping
Factory Reset
N/A
Ok or Back
Display Setup
Language
N/A
English, Deutsch, Italiano
Display Revision
N/A
Contrast
N/A
0-100
Mode
N/A
One Line, One line = Bar graph, Two lines,
Two Lines + Bar graph
Line 1 View
N/A
Differential Pressure, Static Pressure,
Process Temperature, Sensor Temperature
Line 2 View
N/A
Differential Pressure, Static Pressure,
Process Temperature, Sensor Temperature
Bar View
N/A
Differential Pressure, Static Pressure,
Process Temperature, Sensor Temperature