EasyManuals Logo

ABB ACQ580-01 Series User Manual

ABB ACQ580-01 Series
218 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #103 background imageLoading...
Page #103 background image
103
R0-
R4
R5
R6-
R9
EN
DE
ES
FR
IT
RU
SV
ZH
Connect the control cables
See figure H on page 172. It shows an example with one analog signal cable and one
digital signal cable. Make the connections according to the default configuration in
use. The default connections of the Water default configuration are shown in section
Default I/O connections on page 104.
1. Remove the front cover, if not already removed. See section Switch off the power
and open the cover on page 99.
Example of connecting an analog signal cable:
2. Cut an adequate hole into the rubber grommet and slide the grommet onto the
cable. Slide the cable through a hole of the bottom plate and attach the grommet
to the hole.
3. Ground the outer shield of the cable 360 degrees under the grounding clamp.
Keep the cable unstripped as close to the terminals of the control board as
possible. Ground also the pair-cable shields and grounding wire at the SCR1
terminal.
4. Route the cable as shown in the figure.
5. Connect the conductors to the appropriate terminals of the control board and
tighten to 0.5…0.6 N·m (0.4 lbf·ft).
6. Tie all control cables to the provided cable tie mounts.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the ABB ACQ580-01 Series and is the answer not in the manual?

ABB ACQ580-01 Series Specifications

General IconGeneral
BrandABB
ModelACQ580-01 Series
CategoryDC Drives
LanguageEnglish

Related product manuals