40 ACS 300 User’s Manual
Chapter 6 - Control and Parameter Logic
Home
Press and hold the key and the key simulta-
neously for three seconds to move to the OUTPUT f param-
eter from any parameter location.
Table 6-1 Control panel keys.
Control
Panel Key
Secondary
Key
Function
Press to change between Display mode and Setting mode.
Hold down to set the display contrast and:
Press to adjust contrast darker
or
Press to adjust contrast lighter.
Press and hold for three seconds to change between remote control
and local control. Refer to “Panel Operation” on page 39 for an
explanation.
Note! Hardware panel lock prevents local control. Message if key is
pressed: “HARDWARE LOCK S1”.
Hold down for 3 seconds to select the Local control mode:
Transfers the running data to local control (current speed/direction/
start).
Press to start or stop the drive
or
Press to reset an active fault. (Fault is active when the fault LED is
illuminated.)
Press to set motor rotation direction.
Note! This procedure reverses the motor only when the drive is running
in Local control mode. Refer to “Local” on page 39 for additional
information.
To Next Page
Loading...
