Drive module of frame size R7 with bottom exit
15
9 Assemble the top entry clear plastic busbar shroud.
10 Connect the laminated copper bars to the input terminals of the drive module.
11 Fasten the top entry clear plastic busbar shroud to the drive module.
Step Instruction Photo
Remove the
protective film.
Step drill lead-throughs for the
busbars.
9a
9b
Press the top cover on
the sides inwards to
enable its tabs to enter
the slots in the lower
part of the shroud.
Top entry busbar shroud installed
Pass the laminated copper bars through the lead-
throughs and the lower part of the shroud
9c
9d
9d
10
11
11
11
11
11
11
To Next Page
Loading...
