Drive module of frame size R8
31
Drive module of frame size R8
What this chapter contains
This chapter describes the installation of a drive module of frame size R8 into a
600 mm deep, 800 mm wide and 2000 mm high Rittal TS 8 enclosure. The
installation is designed to comply with the limits of IEC/EN 61800-3 for immunity and
emissions of electrical equipment in second environment (includes establishments
connected to a network not supplying domestic premises). The installer is
responsible for the verification. The degree of protection of the installaton is IP20.
Required Rittal parts
For photos and specifications of the parts, refer to www.rittal.com.
Rittal model no. Description Qty
(pcs)
TS 8806.500 Enclosure, width × height × depth: 800 mm × 2000 mm × 600 mm 1
TS 8106.235 Side panel for 2000 mm × 600 mm 2
TS 8612.180 Punched section with mounting flange, outer mounting level for 800 mm horizontal 3
TS 8612.400 Mounting plate 2
TS 8614.640 Mounting plate: 500 mm × 300 mm 1
TS 8614.840 Mounting plate: 700 mm × 300 mm 1
DK 7097.000 C-rail cable clamp for cable diameters of 18 to 22 mm 4
DK 7099.000 C-rail cable clamp for cable diameters of 56 to 64 mm 6
DK 7828.060 C-rail 600 mm 3
DK 7967.000 50 mm spacer for roof plate 4
PS 4199.000 Spacer bracket ?
PS 4375.000 Punched section without mounting flange 395 mm 2
PS 4396.000 Support rail for 600 mm enclosure depth 2
PS 4944.000 Support rail 555 mm 1
SK 3326.200 Air filter 323 mm for 292 mm × 292 mm door ventilation holes 3
SK 3326.607 EMC compatible fan-and-air-filter unit 700/720 m
3
/h, 230 V, 50/60 Hz 1
SV 3574.000 Laminated copper bar Flexibar S. Dimensions: 32 mm × 10 mm, 2000 mm long 3
To Next Page
Loading...
