Drive module of frame size R7 with bottom exit and Rittal cooling unit
27
Installation steps
Install the cooling unit according to the manufacturer’s instructions to the side panel
of the drive enclosure:
1. Cut openings in the side panel of the enclosure for air input and output and power
supply wiring of the cooling unit.
2. Install the cooling unit.
3. Lead the power supply wires through a lead-through grommet into the enclosure.
4. Connect the power supply wires and secure them with cable ties.
Connections in the
cooling unit:
Fastening bolt
Cutting in the side panel
View of the cooling unit power supply
wiring inside the enclosure
L1
L2
L3
400 VAC
To Next Page
Loading...
