About this manual
7
About this manual
What this chapter contains
This chapter describes the intended audience and contents of the manual and refer
to other related manuals.
Target audience
The manual is intended for people who plan the installation and install the drive
module into a Rittal TS 8 cabinet. Read the manual before working on the drive
module. The reader is expected to know the fundamentals of electricity, wiring,
electrical components and electrical schematic symbols.
The manual is written for readers worldwide. Both SI and imperial units are shown.
Safety
WARNING! Follow the safety instructions given in ACS800-04/04M/U4 Hardware
Manual [3AFE64671006 (English)] when installing, operating and servicing the drive.
If ignored, physical injury or death may follow, or damage may occur to the drive,
motor or driven equipment. Read the safety instructions before you work on the unit.
What this manual contains
The manual shows a few installation examples on how to install the drive module
into a Rittal TS 8 cabinet.
The chapters of this manual are briefly described below.
About this manual introduces the manual.
Drive module of frame size R7 with bottom exit describes the installation of a drive
module of frame size R7 in an 800 mm × 2000 mm × 600 mm enclosure.
Drive module of frame size R7 with bottom exit and Rittal cooling unit describes the
installation of a drive module of frame size R7 in an 800 mm × 2000 mm × 600 mm
enclosure when the enclosure is cooled with a cooling unit.
Drive module of frame size R8 and Rittal cooling unit describes how to install a drive
module of frame size R8 into a 600 mm deep enclosure when the enclosure is
cooled with a cooling unit.
To Next Page
Loading...
