Drive module of frame size R7 with bottom exit and Rittal cooling unit
24
• power cable lead-throughs
• control cable lead-throughs
• PE busbar of dimensions 70 mm × 50 mm ×10 mm, copper
• contactor (optional)
• auxiliary voltage transformer when a contactor is installed
• supply disconnecting device and input cable fuses. See the ACS800-04/04M/U4
Hardware Manual [3AFE64671006 (English)] chapters Planning the electrical
installation and Technical data.
• terminal for grounding the control cable shields and self-adhesive strain reliefs to
be mounted next to the RDCU Drive Control Unit. See page 22.
• shroud over the input cable terminal connections and output connections of the
disconnecting device.
Moving, unpacking and assembling the drive module
Follow the instructions given in ACS800-04/04M/U4 Cabinet Installation
[3AFE68360323 (English)]. Fasten the bottom exit kit (+H352) to the drive module
before beginning to install the drive module into the enclosure.
View of the installation
To Next Page
Loading...
