Planning the cabinet installation
34
Drive module of frame size R7 on its back
Support the module from below.
The fastening points are not
sturdy enough to carry the
weight of the module when laid
on its back.
Leave space above the module
for maintenance
Air baffle for preventing cooling
air recirculation
Ensure that the cooling air will flow freely and
is clean. Use filter mats if the input cooling air
is taken near the floor surface and contains
dust.
Prevent dripping water from
entering the drive module.
64796003_bottom_exit_copy<64796003>.asm
Note: Air inlet into the drive module
goes through the front gratings of
the module. Do not cover them.
To Next Page
Loading...
