ABB ACS800-04M - Optional Selection +H363

Mechanical installation of non-pre-assembled units (ACS800-04M)
79
Optional selection +H363
This selection enables the connection of the DC output and the brake resistor output
to the opposite sides of the pedestal. The installation below requires also optional
selection +H356. The UDC- busbar and R- busbar are taken from the +H356 parts,
the R+/UDC+ busbar from the +H363 parts. For instruction on how to connect the
busbars to the pedestal frame, see Connecting the DC busbars to the pedestal
(+H356 and +H363 only) on page 76.
1. Connect the UDC- busbar.
2. Connect the R+/UDC+ busbar.
3. Connect the R- busbar.
2
Pedestal upside down
UDC-
UDC+
R+
R-
U2
V2
W2
DC output connected to the right
1
3