ABB ACS850 - Application Macros; What this Chapter Contains; General

Application macros 51
5
Application macros
What this chapter contains
This chapter describes the intended use, operation and default control connections of
the application macros.
More information on the connectivity of the JCU control unit is given in the Hardware
Manual of the drive.
General
Application macros are pre-defined parameter sets. When starting up the drive, the
user typically selects one of the macros as a basis, makes the essential changes and
saves the result as a user parameter set.
Application macros are activated through the control panel main menu by selecting
ASSISTANTS – Firmware assistants – Application Macro. User parameter sets are
managed by the parameters in group 16 System (page 115).