CONTROLMASTER CM10 | UNIVERSAL PROCESS CONTROLLER, DIN | CI/CM10-EN REV. C
19
7 Access levels and security options
Access Level
Logout
Read O nly
Basic
Advanced
Service
The access level menus are used to enter the Basic and Advanced menus, view all
parameters in read only mode and to logout (return to operator view mode).
To view Access Level menus:
1 From the operator view mode, press
OR
press
to display the available operator menus and use the and keys
to scroll to Enter Config. Mode, then press
. The Access Level menu is
displayed.
2 Use the and keys to scroll to the required/permitted level of access
(basic or advanced), then press
.
Logout Displayed after basic or advanced level are accessed.
Logs the user out of basic or advanced level.
If passwords are set, a password must be entered to access the levels again after selecting log out.
Read Only Enables all parameter settings to be viewed.
Basic Enables access to the basic level and adjustment of totalizer count settings and alarm trip points.
Advanced Enables configuration access to all parameters.
Service Reserved for use by authorized personnel.
Security options
Passwords can be set to enable secure end-user access
at 2 levels: Basic and Advanced. The Service level is
password protected and reserved for factory use only.
Passwords are set, changed or restored to their default
settings at the device setup/security setup parameter.
To Next Page
Loading...
Need help?
General
