ABB DCS 600 - Operation by PC; Drive control

Drive control
Components required:
 plastic optical fibre for distances up to 15 m
 field bus module NxxA-0x; FCI (CI810);
AC70 (PM810); AC80 (PM825)
 Star configuration up to 12 drives for FCI, AC70
and AC80
alternative:
 APC2 + YPQ112 (max. 4 drives) ➀
Functionality:
Depends on the field bus module used, interface
e.g. to:
 PROFIBUS with NPBA-02
 MODBUS+ with NMBP-01
 CS31 with NCSA-01
 AF100 with FCI (CI810) or AC70 (PM810)/
AC80 (PM825) ➀
 further modules on request
You will find more detailed information on data
exchange in the specific fieldbus module docu-
mentation.
Operation by PC
Components required:
 plastic optical fibre for distances up to 20 m
 Monitoring network up to 200 drives (same as
for ACS 600)
 HCS optical fibre cable up to 200 m.
see separate manual Configuration instruc-
tions NDBU 85-95 - Doc no.: (3ADW000100)
Functionality :
 Drives Window software package ➀ for com-
missioning, diagnosis, maintenance and trou-
ble-shooting; structure of connections see Tech-
nical Data
System requirements/recommendation:
 PC (IBM-compatible) with 486 processor or
higher (min. 50 MHz)
 8 MB RAM
 DOS version 5.0 or later
 Windows 3.1, 3.11, Windows95; Windows
NT4.0
 VGA monitor
 3 1/2" floppy disk drive
 PCMCIA or ISA card slot
In addition to the options provided by the
CDP312 control and display panel, there are
further functions available, and these are de-
scribed on the following page.
II F 2-13
➀ For further information see the specific publi-
cations