92 Communication profiles
10 ABOVE_
LIMIT
1 Actual frequency or speed equals or
exceeds the supervision limit (set by the
drive parameter). Valid in both directions of
rotation.
0 Actual frequency or speed within
supervision limit.
11 EXT_CTRL_
LOC
1 External Control Location EXT2 selected.
Note concerning ACS880: This bit is
effective only if the fieldbus interface is set
as the target for this signal by drive
parameters. User bit 0 selection (06.30).
0 External Control Location EXT1 selected.
12 EXT_RUN_
ENABLE
1 External Run Enable signal received.
Note concerning ACS880: This bit is
effective only if the fieldbus interface is set
as the target for this signal by drive
parameters. User bit 1 selection (06.31).
0 No External Run Enable signal received
13…
14
Reserved.
15 FBA_ERROR 1 Communication error detected by the
fieldbus adapter module.
0 Fieldbus adapter communication OK.
Bit Name Value STATE/Description
To Next Page
Loading...
