ABB IEC 60870-5-103 - Signals; Settings

4.1.8.3 Signals
PID-6485-INPUTSIGNALS v5
Table 25: I103USRDEF Input signals
Name Type Default Description
BLOCK BOOLEAN 0 Block of status reporting
INPUT1 BOOLEAN 0 Binary signal Input 1
INPUT2 BOOLEAN 0 Binary signal input 2
INPUT3 BOOLEAN 0 Binary signal input 3
INPUT4 BOOLEAN 0 Binary signal input 4
INPUT5 BOOLEAN 0 Binary signal input 5
INPUT6 BOOLEAN 0 Binary signal input 6
INPUT7 BOOLEAN 0 Binary signal input 7
INPUT8 BOOLEAN 0 Binary signal input 8
RT_START BOOLEAN 0 Trig to set base of relative time
GUID-9E29DE39-EA74-4D62-A2BA-F8E31A3D8757 v2
RT_ST
ART registers the positive transition (0->1) of a pulse and sets the time
from which relative time is derived. Relative time is assigned only to inputs where
the corresponding TypNo parameter is set to Relative. The maximum relative time
and unit conform to the IEC 60870-5-103 standard.
4.1.8.4 Settings
PID-6485-SETTINGS v5
Table 26: I103USRDEF Non group settings (basic)
Name Values (Range) Unit Step Default Description
FunctionType 1 - 255 - 1 5 Function type (1-255)
InfNo1 1 - 255 - 1 1 Information number for binary input 1
(1-255)
InfNo2 1 - 255 - 1 2 Information number for binary input 2
(1-255)
InfNo3 1 - 255 - 1 3 Information number for binary input 3
(1-255)
InfNo4 1 - 255 - 1 4 Information number for binary input 4
(1-255)
InfNo5 1 - 255 - 1 5 Information number for binary input 5
(1-255)
InfNo6 1 - 255 - 1 6 Information number for binary input 6
(1-255)
InfNo7 1 - 255 - 1 7 Information number for binary input 7
(1-255)
InfNo8 1 - 255 - 1 8 Information number for binary input 8
(1-255)
TypNo1 Absolute
Relative
- - Absolute Type identification (TYP)
Table continues on next page
Section 4 1MRK 511 394-UEN A
IEC 60870-5-103 vendor specific implementation
38 670 series 2.2 IEC
Communication protocol manual