ABB IEC 60870-5-103 - Signals; Settings; Supported Information Types

4.2.1.3 Signals
PID-3969-INPUTSIGNALS v5
Table 28: I103CMD Input signals
Name Type Default Description
BLOCK BOOLEAN 0 Block of commands
PID-3969-OUTPUTSIGNALS v5
Table 29: I103CMD Output signals
Name Type Description
16-AR BOOLEAN Information number 16, off/on of autorecloser
17-DIFF BOOLEAN Information number 17, block of differential
protection
18-PROT BOOLEAN Information number 18, block of protection
4.2.1.4 Settings
PID-3969-SETTINGS v5
Table 30: I103CMD Non group settings (basic)
Name Values (Range) Unit Step Default Description
FunctionType 1 - 255 - 1 1 Function type (1-255)
4.2.1.5 Supported information types
Function commands in control direction, pre-defined I103CMD
M11874-53 v6
Function command block in control direction with defined output signals.
Number of instances: 1
Function type is selected with parameter FunctionType.
Information number is defined for each output signals.
Table 31: Pre-defined I103CMD supported indications
INF Description
16 Auto-recloser on/off
17 Teleprotection on/off
18 Protection on/off
1MRK 511 394-UEN A Section 4
IEC 60870-5-103 vendor specific implementation
670 series 2.2 IEC 41
Communication protocol manual