ITS2.1 User Manual rev.04/1SEP622750P0001 10
Important for Inline II: The feeding direction can be set by a jumper connector on ITS adapter unit. When
changing the power direction, these must be changed accordingly, study chapter 9.
4. Give the ITS unit a unique Modbus slaver address (between 1 – 247).
If necessary, the communication parameters must be changed to correspond with system builder’s
settings (factory setting is 247).
5. If an Ekip Com Modbus TCP module is connected, the module’s static IP address can be force set at
Ekip COM Modbus TCP page
After you modified the parameters on each page, click «Apply» button to download
the parameters to ITS unit and activate it
To Next Page
Loading...
