ABB ITS2.1 - ITS Status Parameters; Custom Fields and Error Codes

ITS2.1 User Manual rev.04/1SEP622750P0001 12
ITS STATUS
Operating mode
If set in REMOTE mode, commands sent on
M
odbus are accepted.
R
emote
/Local
indicate LED in front will be lit. A pushbutton in front of the ITS unit can be used
to switch between REMOTE/LOCAL
LED mode
ALIVE MODE: The power LED in front of the ITS unit is flashing. This is a more
reliable power on indication since it requires the software to be up and running.
POWER MODE: There is a steady light in the power LED. A hangup due to software
failure will not be indicated
CUSTOM FIELDS
Tag name
The customer can enter a relevant name
User data
The customer can enter a relevant
data
Switch Installation Date
The customer can enter the switch installation date
MINIMUM CURRENT VALUE
Minimum
current value
Sets the threshold for the minimum value for the measured current to be
displayed, 0.5% or 2% of measured range
ERROR CODE
Error code
If a programming session fails, a code relevant to the wrong parameters is set.
The error code is the Modbus address of the parameter