ABB ITS2.1 - Page 22

ITS2.1 User Manual rev.04/1SEP622750P0001 22
Connections
Connected client
Ther are three IP Addresses of of the client devices connected to the modules.
Static IP Address
Force Static IP address
Off: Dynamic IP address
On: Static IP address
Static IP Address
Displayed with the static IP
Address enabled, it must be selected in order to insert the
IP address of the modules
Static Network Mask
Displayed with static IP Address enabled, it must be selected in order to insert the
subnet mask of the modules
Static Gateway address
Displayed wit
h static IP Adress enabled, it must be selected in the persence of multiple
subnets, in order to insert the IP Address of the mode to which the modules are
connected