ABB PST - Page 85

Low Voltage Products & Systems 85
ABB Inc. • 888-385-1221 • www.abb-control.com AC 1006.9 - 5/03
Chapter 7 - Settings and configuration
Second programmable input (In1)
Select the required function for the input In1.
One of the following functions can be selected:
None No specific function (not activated).
Reset Reset of a fault or overload condition.
Enable When the In1=0 the softstarter stops immediately.
When In1=1 the softstarter is in normal operation.
Overrides all other inputs.
Jog Performs a start ramp until command is released.
The motor stops immediately when the input
opens.
DOL Open/close the bypass contactor
(PSTB370...PSTB1050).
Start3 Start signal for 3rd parameter set-up.
Press Store to save/activate the selected function.