ABB REB670 - Auto Recloser Settings

ANSI04000137-3-en.vsd
ACTIVE
UNSUCCL
READY
3PT2
3PT3
WAIT
CBREADY
TRSOTF
RESET
BLKOFF
BLKON
OFF
ON
BLOCKED
SETON
INPROGR
3PT4
SYNC
INHIBIT
Terminal ‘‘ Master ”
Priority = High
SMBRREC (79)
WAIT
Terminal ‘‘ Slave ”
Priority = Low
CB1
CB2
WFMASTER
WFMASTER
*) Other input/output signals as in previous single
breaker arrangements
PLCLOST
SUCCL
SKIPHS
RSTCOUNT
THOLHOLD
PERMIT1P
PREP3P
3PT1
2PT1
1PT1
3PT5
RESET
BLOCKOFF
BLKON
OFF
ON
INHIBIT
PLCLOST
SKIPHS
CBREADY
SYNC
THOLHOLD
TRSOTF
3PT2
3PT3
3PT4
PERMIT1P
PREP3P
3PT1
2PT1
1PT1
3PT5
ACTIVE
UNSUCCL
READY
BLOCKED
SETON
INPROGR
x
x
SUCCL
RI
RI_HS
CLOSEMD
52a
RI
RI_HS
CLOSEMD
52a
SMBRREC (79)
ANSI04000137 V3 EN-US
Figure 130: Additional input and output signals at multi-breaker arrangement. The
connections can be made "symmetrical" to make it possible to control
the priority by the settings, Priority: High/Low
12.2.3.2 Auto recloser settings
GUID-74980A07-CF89-488F-AB17-E5351D0032EE v1
The settings for the auto recloser are set using the local HMI (LHMI) or PCM600.
This setting guideline describes the settings of the auto recloser using the LHMI.
The settings for the auto recloser are found under Main menu/Settings/IED Settings/
Control/AutoRecloser(79,5(0->1))/SMBRREC(79,5(0->)):X and have been divided
into four different setting groups: General, CircuitBreaker, DeadTime and MasterSlave.
Section 12 1MRK 505 370-UUS A
Control
336 Busbar protection REB670 2.2 ANSI
Application manual