sets the number of positions to x in settings – for example, there will be only the first x
outputs available from the block in the configuration). Also the frequency of the (UP or
DOWN) pulses should be lower than the setting tPulse.
From the local HMI, the selector switch can be operated from Single-line diagram
(SLD).
12.5.3 Setting guidelines
SEMOD115063-294 v6
The following settings are available for the Logic rotating switch for function selection
and LHMI presentation (SLGAPC) function:
Operation
: Sets the operation of the function Enabled or Disabled.
NrPos: Sets the number of positions in the switch (max. 32).
OutType: Steady or Pulsed.
tPulse: In case of a pulsed output, it gives the length of the pulse (in seconds).
tDelay: The delay between the UP or DOWN activation signal positive front and the
output activation.
StopAtExtremes: Sets the behavior of the switch at the end positions – if set to
Disabled, when pressing UP while on first position, the switch will jump to the last
position; when pressing DOWN at the last position, the switch will jump to the first
position; when set to Enabled, no jump will be allowed.
12.6 Selector mini switch VSGAPC
SEMOD158754-1 v3
12.6.1 Identification
SEMOD167850-2 v4
Function description IEC 61850
identification
IEC 60617
identification
ANSI/IEEE C37.2
device number
Selector mini switch VSGAPC - 43
12.6.2 Application
SEMOD158803-5 v8
Selector mini switch (VSGAPC) function is a multipurpose function used in the
configuration tool in PCM600 for a variety of applications, as a general purpose
switch. VSGAPC can be used for both acquiring an external switch position (through
1MRK 505 370-UUS A Section 12
Control
Busbar protection REB670 2.2 ANSI 399
Application manual
To Next Page
Loading...
