RedundantCh is used to set the channel as a redundant backup channel. The redundant
channel takes the CT group setting of the main channel, and ignores the CT group
configured in its own transmit block.
LinkForwarded
is used to configure the LDCM to merge the inter-trip and block
signals from another LDCM-receiver. This is used when the analog signals for the
LDCM-transmitter is connected to the receiver of another LDCM.
Section 18 1MRK 505 370-UUS A
Remote communication
498 Busbar protection REB670 2.2 ANSI
Application manual
To Next Page
Loading...
