In both cases, the switch full name will be shown, but the user has to redefine it when building the
Graphical Display Editor, under the "Caption". If used for the control, the following sequence of
commands will ensure:
ANSI06000421-2-en.vsd
../Control/SLD/Switch
SMBRREC control
WFM
Pilot setup
OFF
Damage control
DAL
../Control/SLD/Switch
SMBRREC control
WFM
Pilot setup
OFF
P: Disc N: Disc Fe
OK Cancel
../Control/SLD/Switch
SMBRREC control
WFM
Pilot setup
OFF
Damage control
DFW
Change to the "Switches" page
of the SLD by left-right arrows.
Select switch by up-down
arrows
Control
Single Line Diagram
Commands
Control
Measurements
Events
Disturbance records
Settings
Diagnostics
Test
Reset
Authorization
Language
Select switch. Press the
Open or Close key. A
dialog box appears.
E
The pos will not be modified
(outputs will not be activated) until
you press the E-button for O.K.
Open Close
ANSI06000421 V2 EN-US
Figure 475: Example 2 on handling the switch from the local HMI.
From the single line diagram on local HMI.
14.6 Selector mini switch VSGAPC
SEMOD158754-1 v3
14.6.1 Identification
SEMOD167850-2 v3
Function description
IEC 61850
identification
IEC 60617
identification
ANSI/IEEE C37.2
device number
Selector mini switch VSGAPC - -
Section 14 1MRK 502 066-UUS B
Control
910
Technical manual
To Next Page
Loading...
