Drive configuration
35
1 MODULE TYPE
This parameter shows the module type as detected by the drive.
The value cannot be adjusted by the user.
If this parameter is undefined, the communication between the
drive and the module has not been established.
2 Comm rate
Defines the baud rate for the Ethernet interface.
3 DHCP
The Dynamic Host Configuration Protocol (DHCP) is an Internet
protocol for automating the configuration of computers that use
TCP/IP. DHCP can be used to automatically assign IP addresses,
to deliver TCP/IP stack configuration parameters such as the
subnet mask and default router, and to provide other configuration
information.
21 Output 3 0…65535 0
22 Output 4 0…65535 0
23 Input 1 0…65535 0
24 Input 2 0…65535 0
25 Input 3 0…65535 0
26 Input 4 0…65535 0
0 = Auto-negotiate
1 = 100 Mbit/s, full duplex
2 = 100 Mbit/s, half duplex
3 = 10 Mbit/s, full duplex
4 = 10 Mbit/s, half duplex
0 = DHCP disabled
1 = DHCP enabled
To Next Page
Loading...
