ABB | SACE Emax 2
External electronic accessories
5 - Ekip Com Modbus TCP
224 | © 2023 ABB | 1SDH001330R1002 - ECN000297030
Configurations via menu
Local bus activation, which is essential for starting the communication between module and Ekip Touch,
is available in the
Settings
menu (page 130).
The following communication parameters can be configured if the module has been correctly detected by
Ekip Touch in the
Settings
-
Modules
menu:
Parameter Description Default
Static IP
address ON
Defines whether the module has the dynamic (Off) or static (On)
IP address.
Se = On all the associated parameters are enabled
Off
Static address
IP address
Enables the static IP to be selected 0.0.0.0
Static Network
Mask
Enables the subnet mask to be selected 0.0.0.0
Static Gateway
address
When there are several subnets, enables the IP address of the
node to which the module is connected to be selected
0.0.0.0
Information in menu
The following information will be available in the About-Modules menu if Ekip Touch has detected the
module correctly:
Information Description
SN and version
Identifier and SW version of the module
IP address
Address of the module, assigned to the module by a DHCP server at the time
of connection to the network in the case of configuration with a dynamic IP, or
can be set via the menu in the event of a static IP.
NOTE:
without a DHCP server, the module automatically adopts a random
IP address within the 169.254.xxx.xxx
range
Network Mask
Subnet mask; identifies the method for recognizing the subnet to which the
modules belong and enables modules to be searched for within a defined set
of recipients.
Gateway address
IP address of the node to which the module is connected, in the presence of
several subnets
TCP Client 1, 2, 3
IP addresses of the client devices connected to the module (in the Server
mode)
MAC address
Address assigned by ABB, with OUI (Organizationally Unique Identifier) equal
to ac:d3:64, which uniquely identifies the manufacturer of an Ethernet device
To Next Page
Loading...
