ABB SACE Emax E4.2 - Page 231

ABB | SACE Emax 2
External electronic accessories
6 - Ekip Com Profinet
228 | © 2023 ABB | 1SDH001330R1002 - ECN000297030
Remote configurations
Additional parameters can be accessed via the service connector (via Ekip Connect) or via a system bus
communication:
Parameter Description Default
Data access
mode
Defines Dataset (acyclic data) access mode
• each individual acyclic register can be accessed in the Legacy
mode using the Slot, Subslot and Index fields (with Slot fixed at
3)
• only complete blocks can be accessed in the Dataset mode; Slot
is fixed at 0, Subslot at 1 and Index defines the block reference
See System Interface for details.
Legacy
Cyclic data
endianess
Establishes whether the register of the cyclic data item is
configured in Big endian or Little endian.
Little endian
Acyclic data
endianess
Establishes whether the register of the acyclic data item is
configured in Big endian or Little endian.
Big endian
Remote information
Certain integrative information concerning the version and state of the module is available via service
connector (via Ekip Connect) or through communication via system bus, i.e.,HW and Boot version, CRC
state (correctness of SW in module), DCP Name, network settings (IP address, Network Mask, Gateway
address)