ABB SACE Emax E4.2 - Wink; Glitch; Wizard Reset

ABB | SACE Emax 2
128 | © 2017 ABB | 1SDH001330R0002 - ECN000058721 Rev. A Ekip Touch protection trip unit | 21 - Additional Ekip Touch functions
Wink
The command allows the power-on LED on the protection trip unit to flash at 3 Hz so as to physically identify
a trip unit that would not be identifiable in other ways.
3 Hz flashing is disabled by sending another Wink command or by switching off the trip unit.
Glitch
The commands of Glitch 16 to 23 activate the respective glitch registers, which can be used for customizing
programmable functions or output contacts.
Wizard Reset
Reset Wizard: the Wizard window appears the first time the trip unit comes on and can be used to enter
some of the trip unit and circuit-breaker parameters.