ABB SACE Emax E4.2 - Start Page; Navigation

ABB | SACE Emax 2
40 | © 2017 ABB | 1SDH001330R0002 - ECN000058721 Rev. A Ekip Touch protection trip unit | 1 - Layout of the interface
Start page
To open the page, press the HOME key until the page is displayed.
The system returns automatically to this page after some minute of inactivity.
The default start page is the Histograms page.
Any graphical level 2 page (accessible from the main page) can be set as the start page, except for the
pages Alarm List and Menu.
To set a page as the start page, you need to:
1. Open the page
2. Keep the HOME key pressed for at least 5 seconds.
3. Select Yes in the confirmation window that appears on the display.
Navigation
The following table shows how to access the pages through the keys:
To open… Perform these operations…
The main page Press the HOME key.
The start page Press the HOME key, until the start page appears.
The Alarm List page
If there are messages present, if the diagnostics bar is displayed:
• Touch the display in the message display area, or
• Press the iTEST button.
The Info page Press the iTEST key, until the Info
(1)
page appears.
(1)
The Info page displays five lines of twenty characters each containing alphanumeric data that the customer
can insert through the Ekip Connect software (see the chapter "16 - Other accessories", and the paragraph "
Ekip Connect software" on page 245). To be displayed, it must be enabled (see the chapter "6 - Menu", and
the paragraph "Settings Menu" on page 49).