ABB | SACE Emax 2
262 | © 2017 ABB | 1SDH001330R0002 - ECN000058721 Rev. A Mechanical accessories | 2 - Mechanical safety accessories
2 - Mechanical safety accessories
KLC: open position key lock
The KLC locks the circuit-breaker in the open position.
It can also be used during maintenance activities on the circuit-breaker after removal of the cover of the
accessory area.
The KLC lock is available with two types of locking:
• lock with different key code numbers (for a single circuit-breaker).
• lock with the same key code number (for more than one circuit-breaker). The maximum number of key
code numbers available is five.
If set up appropriately, the KLC-A lock can work with four other types of locks:
• Ronis
• Profalux
• Kirk
• Castell
NOTE: the supply of Ronis - Profalux - Kirk - Castell locks is at customer's expense.
KLC for E1.2 KLC for E2.2 - E4.2 - E6.2
Information on the assembly is available on the website http://www.abb.com/abblibrary/DownloadCenter/, in
particular for E1.2 in the kit sheets
• 1SDH000999r0702 for key locks with lock supplied by ABB
• 1SDH000999r0703 for the key locks with pre-engineering for Ronis - Profalux - Kirk locks
• 1SDH000999r0718 for the key locks with pre-engineering for Castell locks
and for E2.2-E4.2-E6.2 in the kit sheets:
• 1SDH001000r0702 for key locks with lock supplied by ABB
• 1SDH001000r0703 for the key locks with pre-engineering for Ronis - Profalux - Kirk locks
• 1SDH001000r0718 for the key locks with pre-engineering for Castell locks
PLC: padlock
The PLC locks the circuit-breaker in the open position.
It is available in two types:
• lock usable with a maximum number of three padlocks with a diameter of 4 mm - 0.16"
• lock usable with a maximum number of two padlocks with a diameter of 8 mm - 0.32"
• lock for a padlock with a diameter of 7 mm - 0.28" or for a latch chain
NOTE: The padlocks are at customer's expenses.
PLC for E1.2 PLC for E2.2 - E4.2 - E6.2
Information on the assembly is available on the website http://www.abb.com/abblibrary/DownloadCenter/,
in particular for E1.2 in the kit sheet 1SDH000999r0706 and for E2.2-E4.2-E6.2 in the kit sheet
1SDH001000r0706.
To Next Page
Loading...
