ABB SACE Emax E4.2 - Page 203

ABB | SACE Emax 2
Electronic accessories | 5 - Ekip Signalling 4K module197 | © 2017 ABB | 1SDH001330R0002 - ECN000058721 Rev. A
Continued from the previous page
The following table shows the path from the display for accessing information on the module:
About
Protection Unit
Circuit-breaker
Modules
…
Ekip Signalling 4K
…
Power Controller
Information that can be displayed on the module:
• The logical state of the inputs (“Off” if not active, “On” if active).
• The state of the output contacts (“Open” if open, “Closed” if closed).
The following tables illustrate the paths from the display to access the pages for programming the actions you
wish the trip unit to perform in the event of an input being activated.
NOTE: the selection of an action opens a list of the programming parameters, that is, a list
of the events for which the action can be performed, and the related delay. For details on the
parameters, see the chapter “20 - Operating features", and the paragraph "Functional
characteristics" on page 124.
Advanced
…
Current thresholds
Functions
(1)
External Trip
Trip RESET
(1)
Menus available with the Double Set function disabled (see the chapter "6 - Menu", and the paragraph "
Settings Menu" on page 49.
Advanced
Set A
Set B
Functions
(1)
External Trip
Trip RESET
Turn on SET B
(1)
Menus available with the Double Set function enabled (see the chapter "6 - Menu", and the paragraph "
Settings Menu" on page 49.
Measurements
…
Frequency
Energy
(1)
Energy counters
Reset counters
RESET Energy
Peak factor
…
(1)
Menu available with Ekip Measuring or Ekip Measuring Pro modules.
Continued on the next page