ABB SACE Emax E4.2 - Page 211

ABB | SACE Emax 2
Electronic accessories | 6 - Ekip Signalling 2K modules205 | © 2017 ABB | 1SDH001330R0002 - ECN000058721 Rev. A
Continued from the previous page
The following tables illustrate the paths from the display to access the pages for programming the actions you
wish the trip unit to perform in the event of an input being activated.
NOTE: the selection of an action opens a list of the programming parameters, that is, a list
of the events for which the action can be performed, and the related delay. For details on the
parameters, see the chapter “20 - Operating features", and the paragraph "Functional
characteristics" on page 124.
Advanced
…
Current thresholds
Functions
(1)
External Trip
Trip RESET
(1)
Menus available with the Double Set function disabled (see the chapter "6 - Menu", and the paragraph "
Settings Menu" on page 49.
Advanced
Set A
Set B
Functions
(1)
External Trip
Trip RESET
Turn on SET B
(1)
Menus available with the Double Set function enabled (see the chapter "6 - Menu", and the paragraph "
Settings Menu" on page 49.
Measurements
…
Frequency
Energy
(1)
Energy counters
Reset counters
RESET Energy
Peak factor
…
(1)
Menu available with Ekip Measuring or Ekip Measuring Pro modules.
Settings
Circuit-breaker
…
Ground protection
Installation
Main frequency
Modules
…
Functions
Switch On LOCAL
Signalling RESET
Power Controller
…
System
Functions
YO Command
YC Command
Maintenance
Continued on the next page