1-2 3HDA000057A8519-001 Torch Service Center - TSC 2013
Assembly instructions
The quality, performance and functionality of the TSC 2013 are only attained if it is used in welding
units designed by ABB. The TC/TSC 2013 may only be used in the intended area of use (war-
ranty!).
ABB reserves the right to make technical modifications necessary to improve the TC/TSC 2013.
Deviations from the contents or from the illustrations in these operating instructions are therefore
possible.
Warranty
Warranty claims can be made in the case of
• designated use
• proper operation
• compliance with maintenance instructions
• use of genuine spare parts
• compliance with safety instructions.
The warranty covers elimination of faults and the use of parts which are shown to have become
faulty or unusable due to material, design or production faults. Replaced parts become the prop-
erty of the supplier.
Excluded from the warranty are
– wearing parts,
– lubricants,
– external cable connections,
– cables subjected to torsion and bending etc.
Also excluded is damage due to causes for which the manufacturer is not responsible such as
– force majeure,
– natural wear and tear,
– improper handing,
– interventions by third parties,
– excessive loading,
– unsuitable equipment and ambient conditions which do not meet ABB guide values.
In the event of malfunctions within the warranty periods the faulty item is to be sent to ABB. Notes
attached by you on the fault that has occurred make it easier for our servicing department to elim-
inate the damage.
Target group
These assembly instructions are aimed at all persons who work on the system/machine or its com-
ponents. Specialist knowledge on the operation of the system/machine is assumed for an under-
standing of the assembly instructions.
Product liability and and warranty are invalidated by
unauthorised interventions and non-designated use!
To Next Page
Loading...
Need help?
General