Remote switch-on/switch-off
This command can be used to switch off/switch on the inverter via an
external (remote) command.
This function must be enabled in the menu and when active, switching
on the inverter, besides being dictated by the presence of normal param-
eters which allow the inverter to be connected to the grid, also depends
on the external command for switching on/off.
Remote Firmware Update Function
The inverter rmware can be updated remotely using the internal web-
server dedicated section.
Reactive power feed into the grid
The inverter is able to produce reactive power and can feed this power
into the grid via the phase factor setting. Managing the feed can be con-
trolled directly by the grid company via a dedicated RS485 serial inter-
face or through the internal web user interface.
Power feeding modes vary according to the country of installation and
the grid companies. For detailed information on the parameters and
characteristics of this function, contact ABB directly.
Limiting the active power fed into the grid
The inverter, if enabled and set through the internal web user interface,
can limit the amount of active power fed into the grid by the inverter to the
desired value (expressed as a percentage).
To Next Page
Loading...
Need help?
General