Opening the front cover
WARNING! ELECTRIC SHOCK HAZARD! Some inverter parts may
be subject to voltages that could be hazardous for the operator. Be-
fore performing any work on the inverter, refer to “Inverter total de-
energization and safe access” chapter on this manual to know all the
necessary steps to safely operate on the inverter.
The main connections are made on the lower part (outside) of the in-
verter. If required, install the accessories and make the necessary con-
nections, unscrew the 8 screws using a TORX T20 key and open the
front cover
05
; while removing the screws, pay special attention since
additional screws are not supplied..
Do not open the inverter in the case of rain, snow or a high level of humidity (>95%)
Caution! It’s necessary to hold the front cover during the screws removal to avoid his falling
(the front cover isn’t secured to the inverter’s chassis).
1
8
6
5
7
3
2
4
To Next Page
Loading...
Need help?
General