What You See on the Display What You Do Comments
6-3
Questions? Refer to Page 10-10 for Technical Support Instructions.
9. Bring prociency survey specimens to
room temperature. Mix each specimen
well according to instructions from the
survey provider. Wipe away any specimen
on the tip of the vial before squeezing the
vial and applying a drop to the test strip
target area, covering the entire area. Aer
applying the sample, recap the vial tightly.
When sufficient sample has been applied,
the monitor beeps, displays Sample
Accepted and automatically starts the test.
For a detailed description of the test strip
target area, refer to the Test Strips section of
Chapter 1.
10. Wait for the monitor to analyze the
sample and display the test result.
The monitor counts down then displays
the test result. If an error is detected during
the assay, the assay is terminated and no
result is displayed. Once the assay begins,
all key presses are ignored until the assay is
completed.
11. If required, scan or manually enter the
comment code, and press Enter.
If there is no prompt to enter a comment
code, skip down to step 12.
The monitor may be enabled to scan or enter a
1- to 2-digit comment code.
12. You can select one of the following
options:
Press 1 – Next Test.
Press Menu to return to the Menu
Mode.
Press On/Off to turn off the monitor.
Remove the test strip from the monitor
and discard it when finished testing.
Follow your facility’s biohazard disposal
policy.
The display shows:
Sample ID (s: prompt)
Comment Code (Number in box)
Test Type (Glucose)
Date and Time of test
Operator ID (o: prompt)
Note that test date and time alternates with
Operator ID.
If 1 is selected, the Scan or Enter Sample
ID screen will appear. Return to step 5
to perform the Next Test with another
proficiency sample.
105 mg/dL
105 mg/dL
Chapter 6: Proficiency Test
To Next Page
Loading...
Need help?
General
