EasyManua.ls Logo

Abus ABUCompact GM2 - General Information; At the Start

Abus ABUCompact GM2
108 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Gene r a l i n fo r m ati o n | At t he s t art
5
AT THE START
USING THIS PRODUCT MANUAL
The following symbols are used in this product
manual:
DANGER TO PERSONS!
This warning notice indicates
hazards for persons.
DANGER FROM ELECTRIC
SHOCK!
This warning notice indicates
hazards for persons due to incorrect
handling of the electrical system and
electricity.
DANGER FROM FALLING
SUSPENDED LOAD!
This warning notice describes
hazardous situations that can lead
to the suspended load falling.
NOTICE OF POSSIBLE D
AMAGE!
This notice describes situations in
which a component could be
damaged.
This is an instruction regarding an action and
prompts you to perform a work step.
This is the result of an action and describes
what happens on the device.
This is a list.
ONLY WITH...
A section that appears in a box framed by a
dashed line is only applicable for certain types,
versions or options. The condition to which the
section applies is specified at the beginning in the
heading “Only with...”.
INSTRUCTIONS FOR THE PRODUCT
MANUAL
Read the product manual through carefully before
beginning work. Also be sure to observe additional
product manuals for accessories and components.
Afterwards, keep the product manual available in the
vicinity of the crane. It must be accessible to all who
work with or on the crane.
In the case of reselling or hiring out, always provide
the product manual together with the crane.
PROPER USE
The chain hoist is suitable for the lifting and lowering
of attached loads.
The chain hoist is designed for these applications:
Independently as a solo chain hoist for the
stationary lifting and lowering of loads.
On a trolley running along an I-beam for
moving loads in a linear direction.
On a jib crane (with hoist trolley) for moving
loads in a circular direction.
On an HB crane installation for all-round
moving of lightweight loads.
On a single girder travelling crane (with hoist
trolley) for all-round moving of loads.
During operation, observe the classification
according to FEM, duty cycle and switching
rate.
Only use the chain hoist within its theoretical
service life.
Do not use in aggressive environments.
Long-term usage only in weatherproof areas.
Temporary use outdoors in rain or snow is
permitted, preferably with electronic control.
GENERAL INFORMATION
THIS SECTION APPLIES TO ANYONE WHO LIFTS LOADS USING THE CRANE,
PERFORMS WORK ON THE CRANE, OR WORKS NEARBY.

Table of Contents