Abus ABUCompact GM2 - A Va I L a B L E a C C E S S O R I E

Ma in t e nan c e | Ava i l abl e a c ces s ori e s
84
AVAILABLE ACCESSORIES
SHORTENING THE CONTROL CABLE
The sheath of the control cable serves to protect the
wiring while also acting as a strain reliever. Therefore
do not simply wind up the control cable and glue the
ends together to shorten it. This would eliminate any
function as a strain reliever.
Kit for shortening the
control cable
To shorten the control cable, use the kit for
shortening the control cable sheath,
AN 308859.
LENGTHENING THE CONTROL
CABLE
Existing control cable
Additional control cable
To lengthen the control cable, use the kit for
lengthening the control cable sheath, AN
102282.
INSTALLING ADDITIONAL STRAIN
RELIEF
The sheath of the control cable serves to protect the
wiring while also acting as a strain reliever. In some
cases it can be useful to install an additional strain
relief.
Additional strain relief
Use the kit for strain relief, AN 109795 for
additional strain relief.
CONNECTING THE CHAIN HOIST
CEE connector with
phase inverter
Flexible connection
cable, 10 m
Bayonet connector
To connect the chain hoist, for example, use
the set “Chain hoist connection cable” AN
316482.
If necessary, reverse the phases with the
phase inverter in the CEE connector. See the
subsection “Checking the rotary field” in the
main section “Connecting the crane to the
mains supply” of the “General Product Manual
for ABUS Cranes”.