142
9.11 ABUS CMS: Advanced setting options
Below is a brief overview of the setting options via remote configuration with the ABUS CMS
software.
Each monitor and each door video module will appear in the network as a separate network
device, regardless of whether the device is connected via 2-wire or PoE.
Remote settings for TVHS20000(S), TVHS20010(S), video door module:
“System” section
Device
Information
General information about firmware, serial
numbe
General Device name and device ID (not relevant
for door intercom system)
Time Settings for date/time, summer time and
NTP serve
Maintenance Maintenance menu for firmware update,
set factory settings and restart device
User Menu is not used
RS485 Menu is not used
“Intercom” section
ID
Configuration
“Device type” must always be on “Outdoor
unit”. Please do not change any numbers
for the units “Period, Building, Unit, Floor”
as these values are not needed here.
Back doors are set up under “No.”. 0 =
main doors, “1” – “9” = back doors.
Please consult the chapter “Setting up
back doors”. (See Installation and
operating information)
Time
Parameters
Max talk time: Maximum conversation
duration for an accepted call. (90-120s)
Max Msg time: Recording time for
answering machine (30-60s)
Permission
Password
3 additional PIN codes (6-digit) can be set
here to use in combination with
TVHS20030.
Access and
Elevator
Control
Door. No.: Select between relay output 1
and 2.
Open door time: Determines how long
the relay should engage the door opener.
(1-255s)
“Door name” and “Card encrypt” not
used.
IO
Input/Output
Settings for digital inputs (for emergency
door opener) and the relay for door
opener.
To Next Page
Loading...
Need help?
General
