VIRUS CLASSIC MANUAL 81
The Parameters
rotate the knob towards the center position. When the knob is set to the far right position, you will
hear Filter-2 exclusively, whereas Filter-1/Saturation is blended into the mix as you rotate the knob
towards the center position.
Consequently, you must set FILTER BALANCE to the center position if you want both filters in series
(in equal amounts) in the signal path.
CUTOFF 2 (OFFSET)
Controls the cutoff frequency of Filter-2. Normally, CUTOFF 2 does not operate absolutely, but rela-
tively to CUTOFF: The cutoff frequency of the second filter is subordinate to the CUTOFF value you
determined for the first filter. However you can use the CUTOFF 2 knob to dial in a relative +/- devi-
ation in frequencies, i.e. a higher or lower frequency (OFFSET). When you set CUTOFF 2 to the
center position, both filters have the same CUTOFF frequency. In FILTER EDIT Menu, you can
access CUTOFF LINK ON/OFF to sever the link between CUTOFF and CUTOFF 2. In this case the
two knobs CUTOFF and CUTOFF 2 are independent cutoff controls for Filters 1 and 2, respectively.
To Next Page
Loading...
