Accu-Chek Aviva User Manual

Inserting a Lancet Drum
You must first load the drum into the lancing device to get it ready for use.
correctly inserted
drum
1. Remove the cap by
pulling it straight o. It
is not a twist cap. The
easiest way to do this
is to place your thumb
to the side of the notch
as seen in the
illustration.
2. Insert a new drum,
white end first, until it
stops. It clicks into
place.
3. Slide the cap on until it
stops by aligning the
notch on the cap with
the notch on the
device.
4. You are now ready to
use the first lancet. The
lancet counter on the
device shows a
number 6, meaning
you have 6 new
lancets remaining.
NOTE
Once the drum is inserted into the lancing device, do not remove the drum until completely used. The drum
cannot be reinserted.
29

Accu-Chek Aviva Specifications

General

Sample Size	0.6 µL
Test Time	5 seconds
Coding	No coding required
Battery Life	Approximately 1000 tests
Memory	500 test results
Battery Type	1 x 3V lithium (CR2032)
Operating Humidity	10% to 90% RH
Meter Weight	59 g
Measuring Range	10 mg/dL to 600 mg/dL
Automatic Shut Off	After 90 seconds of inactivity