17
Introduction
1
Reliability
The meter checks each test strip. If it finds a defective strip, it lets you
know before you apply blood.
Blood volume checking
The meter can tell when you have applied sufficient blood (approxi-
mately 1.5 µL (1 microlitre = 1 thousandth of a millilitre)). It waits until
then before starting the test. If the test does not start, you may apply
more blood.
Alarm clock function
The meter can remind you to test your blood glucose. You can set an
acoustic signal to remind you at three different times.
Hypo indicator function
In order to look out for unusually low results you can set a hypo indica-
tor level (hypo threshold). If a result is below the level you have set, a
symbol in the display and an acoustic signal (provided it is set to on)
prompt you to check your result carefully to see if you are heading
towards a possible hypo (low blood glucose).
Downloading data to a computer
The meter has an infrared window. You can download results to a com-
puter running the appropriate software or to special analysis systems.
AC_CP_LCM_Manual_EN-UK final.indd 17_CP_LCM_Manual_EN-UK final.indd 17 20.6.2007 11:03:5720.6.2007 11:03:57
To Next Page
Loading...
Need help?
General
