Accu-Chek Performa Operator's Manual

18
Flagging Test Results
It is possible to ag a test result with an asterisk ( ) for a special result.
When the results in memory are reviewed, this ag is a reminder of a
special result.
1. Perform a test.
2. With the test result on the display, and the test strip STILL IN THE
METER, press
or once. The appears in the lower right corner.
3. Remove and discard the used test strip and blood collection device per
facility infection control policy.
ag
Totestbloodglucoseyourequireapproximately0.6μLofblood.Avoidproducinglarge
blooddropsonthepatient’snger.Wheretheblooddropsaretoolarge,themetermay
come into contact with the blood. Wipe off any large blood drops. Test using the blood
drop that forms again at the puncture site.
Residues of water or disinfectant on the skin can dilute the blood drop and so produce
false results.
After a successful test, the meter turns itself off 5 seconds after the test strip is
removed.
Dispose of used lancets, test strips or disposable lancing devices according to local
health and safety regulations.

Accu-Chek Performa Specifications

General

Sample Size	0.6 µL
Test Time	5 seconds
Meter Dimensions	94 x 52 x 21 mm
Measurement Range	0.6-33.3 mmol/L
Memory Capacity	500 results
Battery Type	1 x CR2032 lithium coin cell
Automatic Power Off	90 seconds after last user action
Operating Humidity	10 to 90% RH
Storage Conditions	10% to 90% RH
Meter Weight	59 g (with battery)