88
Rev 2.1
Configure System Configuration Temperature Units Textbox (Default: Fahrenheit)
x Select Fahrenheit to show temperature in Fahrenheit
x Select Celsius to show temperature in Celsius
This parameter determines whether temperature is represented in units of Fahrenheit or Celsius degrees.
5-24.7 To Turn On And Off The Unit Using Burner Switch
Operation Burner Switch Button (Default: Yes/True/On)
This parameter enables or disables the burner control. When it is off, the burner will not fire.
5-24.8 To Enable Pump Test
Diagnostics Diagnostics Test Pump Test Button
Enables the installer to verify that the correct pump contacts are on or off. The Start Test button will test all pump
contacts; pressing an individual pump tests that pump contact only.
5-24.9 To Enable Modulation Test
Diagnostics Diagnostics Test Modulation Test Button
Enables the user to verify that the unit is firing at the correct rate.
5-24.10 To Enable Pilot Test
Diagnostics Diagnostics Test Pilot Test Button
Enables the user to verify that the pilot valve is functioning properly. The installer can also perform adjustments for the
pilot flame.